Skip to main content
All CollectionsPoint of saleInstall receipt printers
Setting up your EPSON TM-M30III receipt printer
Setting up your EPSON TM-M30III receipt printer

This article will guide you through the installation of your wireless receipt printer.

Updated over a week ago

1. Unbox and set up your printer

Follow this video to connect the necessary cables and load the paper: 🔗 Watch the setup video

Insert a thermal, continuous paper roll with the following specifications:

  • Paper width: 80mm

    Screenshot 2023-08-25 at 09.41.13
  • Paper thickness: 0.06mm - 0.1mm

  • Maximum roll diameter: 83mm

2. Connect your printer to Wi-Fi

To connect your printer to your Wi-Fi network, follow the steps in this video:
🔗 Watch the Wi-Fi setup video

3. Install your printer’s driver on your POS system

Step 1: Download the driver

Click the link below to download the printer driver:
🔗 Download EPSON driver

Step 2: Extract and install

  1. Locate the downloaded .zip file and extract it to a folder.

  2. Inside the extracted folder, run APD_607R1_m30III and follow the on-screen installation instructions.

Step 3: Configure the printer settings

If the EPSON TM Printer Settings software does not start automatically after installation, you can manually open it:

  • In the Windows search bar, type EPSON APD6 - TM Printer Settings and open the application.

If this printer is the main receipt printer, adjust the settings as shown in the screenshot below (full receipt).

If this printer is the kitchen receipt printer, adjust the settings as shown in the screenshot below (reduced receipt without prices).

Your printer’s IP address is printed on the receipt generated during the Wi-Fi setup process. It will look something like this:

📌 Example IP address: 192.168.xxx.xxx

Once you've completed these steps, your printer should be ready to use!

Follow this article to automatically print receipts after a sale.

Did this answer your question?