Payment terminals
      Back to home
      1. Smeetz Knowledge Base
      2. Manage equipment
      3. Payment terminals

      Setup your V210 payment terminal

      This article explains how to install the payment terminals to start onsite sales.

      1. Supplied components

      • V210 payment terminal
      • Power supply
      • SIM card
      • Receipt paper roll 57 x 40 mm (Width x Diameter)

      2. Hardware installation

      These are the steps to get your new V210 payment terminal up and running.

      1. Inspect the terminal.

      2. Insert the receipt paper roll.

        1. Pull up the latch of the paper compartment and swing the cover downwards.
        2. Insert the paper roll making sure the paper sticks out a bit.
        3. Close the cover of the paper roll compartment.
      3. Turn on the terminal by connecting it to a power source.
        1. During startup the display turns on and off a few times. Let the battery charge for at least four hours while you continue with the next steps (they can take 45 min to 3h to charge and load the configuration)
        2. If you turn on the payment terminal for the first time or after it was off for a long time, it may make a maintenance call to synchronize the configuration and update the software. This can take 10 to 20 minutes.

      Turn on the terminal

      • Connect the terminal to a power supply.
      • Or press and hold the Confirm key until the display turns on. The battery charge level needs to be high enough for the terminal to turn on.

      Turn off the terminal

      1. Go to Settings and select Power.
      2. Enter your passcode.
      3. Select Power off and confirm.
      You can also press and hold the Cancel key until (after 5 - 20 seconds) the display turns off.

      3. Payment terminal configuration

      For some settings you will need a passcode and for others not. Ensure that you have saved the password given to you by your Account Manager.

      • No passcode required:
        • Device info
        • Diagnostics
      • Admin & Settings passcode:
        • Configuration
        • Network
        • Software
        • Power
      1. The terminal have an integrated sim card and will connect to the 4G automatically. First, open the settings to connect to the Wifi
        1. click on "9" and the "green button" 
        2. On the terminal display, select Configure network > Select Wi-Fi > Turn on the Wi-Fi toggle switch.
        3. Click 3x on the red button to go back to main screen
      2. Then, click on "board terminal" to load the configuration > select your store > confirm
        1. Check from time to time if you need to confirm at other steps

      Your V210 terminal can automatically switch to processing payments using a cellular connection when the internet connection fails. Adyen terminals come with a pre-installed and activated SIM card so you can use the cellular network immediately to board the terminal.

      Link to the full Adyen user manual